#Iei keypad programming manual install#

When mounting the 212w outside, use a weatherproof back box and apply silicone to the area where the wires enter the case. Connect the positive (+) lead of your power supply to the terminal strip (TS1) V+ input. IEI recommends using a filtered and regulated power supply after you are familiar with the Programming section.

4.2 Wiring the 212e Keypad to a Maglock (Fail-Safe) 4.3 Wiring the 212e Keypad to an. Section 2: Specifications Section 3: Mounting Section 4: Wiring.

If you cannot ground the power supply, then you must ground the keypad housing. Section 1: Features and Product Description. Wire the transorb in parallel with the lock power terminals.Īlso, to avoid ESD (electro-static discharge) from interfering with the operation of the keypad, ground the negative terminal of the keypad to earth ground.

#Iei keypad programming manual install#

To prevent electrical kick back voltage from damaging the keypad, when using an electrical locking device, you MUST install the transorb as close as possible to the lock. Also, the voltage selection jumper on the main circuit board is no longer required. This product was re-designed using a new manufacturing technology, which changed the physical appearance of the keypad electronics. IEI 212e Standalone TM Keypad Installation/ Programming Manual Contents Section 1: Features and Product Description 1.1 Features 1.2 Product Description Section 2: Specifications Section 3: Mounting Section 4: Wiring 4.1 Wire Harness Configuration 4.2 Wiring the 212e Keypad to a Maglock (Fail-Safe) 4.